Cisco SCE 1000 2xGBE Installation And Configuration Manual page 79

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use
'0' to allow all:
The maximum number of GET communities is 20.
Step 5
Enter up to 20 SNMP GET communities as described in step 3 and step 4.
Would you like to add another SNMP GET community? [no]:
Type the SNMP SET community name and press Enter.
Step 6
The SNMP agent that resides inside the SCE 1000 will respond only to SET requests that use this
community string.
Enter SNMP SET community name:
Note that there is no default for this parameter.
Assign an access list to restrict the SNMP management stations that may use this SET community.
Step 7
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use
'0' to allow all:
The maximum number of SET communities is 20.
Step 8
Would you like to add another SNMP SET community? [no]:y
Enter up to 20 SNMP SET communities as described in step 6 and step 7.
Would you like to add another SNMP SET community? [no]:
Step 9 Enter the SNMP trap managers menu.
Would you like to configure SNMP trap managers? [no]: y
Type y and press Enter.
The SNMP trap managers dialog begins.
If you choose not to configure SNMP trap managers, the dialog skips to the authentication failure
trap status. (See step 14.)
Step 10 Type the trap manager IP address and press Enter.
Enter SNMP trap manager IP address:
Note that there is no default for this parameter.
Type the trap manager community string and press Enter.
Step 11
Note that there is no default for this parameter.
Enter SNMP trap manager community string:
Step 12 Type the number of the trap manager SNMP version (1 or 2c) and press Enter
OL-7821-05
To add more entries, type y and press Enter
•
• Would you like to add another SNMP GET community? [no]:y
• When all entries have been added, press Enter
To add more entries, type y and press Enter
•
When all entries have been added, press Enter
•
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Initial System Configuration
5-17