Cisco SCE 1000 2xGBE Installation And Configuration Manual page 67

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Parameter
enterprise traps status
system administrator
Topology Configuration
connection mode
link bypass mode on
operational status
redundant SCE 1000
platform?
link bypass mode on non-
operational status
operational status of the
SCE after abnormal boot
Following are some general instructions regarding the setup dialog:
All default values appear in square brackets [default].
•
If no value appears in the brackets [], or more than one option appears [yes/no], then this
parameter does not have a default value.
To accept the default value, press Enter.
•
• If you need more information about any parameter, type ? and press Enter.
A help message will appear describing the expected format of the parameter and any other
requirements.
To jump to the end of the setup dialog at any point, accepting all remaining default values,
•
press ^z.
In certain cases, there will be two or more logically related parameters within a menu. In these
•
situations, it is not permitted to jump to the end of the setup dialog until all related parameters
are configured. If you try to jump to the end of the setup dialog, the following message will
appear: "
Certain groups of related parameters, such as time, date, and SNTP settings, form sub-dialogs
•
or menus within the setup dialog. You may skip an entire menu, thereby accepting all default
values for the parameters within the menu.
Each group of related parameters is prefaced by a question, asking whether you want to enter
the menu. To skip the menu, answer no ("n") to the question.
E
XAMPLE
Would you like to enter the SNMP configuration menu? n
To abort the setup dialog at any point without making any configuration changes, press ^c.
•
All changes already entered will be lost, with the exception of time settings.
OL-7821-05
Definition
Set the status of the enterprise traps. (See Traps.)
Name of the system administrator.
Is the SCE 1000 installed in inline topology or receive-only using an
optical splitter?
When the SCE 1000 is operational, should it bypass traffic or not?
Is there a redundant SCE 1000 installed as a backup?
When the SCE 1000 is not operational, should it bypass traffic or cut it
off?
After a reboot due to a failure, should the SCE 1000 remain in a Failure
status or move to operational status provided no other problem was
detected?
Sorry, Skipping is not allowed at this stage
:
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Initial System Configuration
."
5-5