Omron H3DE-M2 Manual page 14

H3DE
J ENVIRONMENT
When using the Timer in an area with excess electronic noise,
separate the Timer, wiring, and the equipment which generates
the input signals as far as possible from the noise sources. To
further prevent electronic interference, shield the input signal
wiring.
Organic solvents (such as paint thinner), as well as very acidic or
basic solutions can damage the outer casing of the Timer.
Do not use the Timer in places where it is exposed to dust,
corrosive gas, or direct sunlight.
When storing the Timer, make sure that the ambient temperature
and humidity are within the rated values. Leave the Timer at
room temperature for at least three hours before using the Timer
if it has been stored at an ambient temperature of - -10°C or
below.
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.
OMRON ELECTRONICS LLC
One East Commerce Drive
Schaumburg, IL 60173
1-800-55-OMRON
Cat. No. GC TMCN1
R
OMRON ON- -LINE
Global - - http://www.omron.com
USA - - http://www.omron.com/oei
Canada - - http://www.omron.com/oci
3/02 Specifications subject to change without notice.
J RELAY LIFE EXPECTANCY
Built-in relay for the H3DE: G6RN; 50,000 operations min.
(8 A at 250 VAC, resistive load at 360 operations/h.)
OMRON CANADA, INC.
885 Milner Avenue
Scarborough, Ontario M1B 5V8
416-286-6465
H3DE
Printed in U.S.A.