Jog Mode - Graco E Series Operation

Jog Mode

Jog mode has two purposes:
• It can speed fluid heating during circulation
• It can make pump repair/replacement easier. See
repair manual.
1.
Turn main power ON
2.
Check that motor
play may show dashes or pressure).
34
.
is OFF (LED is off; dis-
3.
Press to select J 1 (jog speed 1).
4.
Press motor
5.
Press or
(J 1 through J 10).
Jog speeds correlate to 3-30% of motor power,
but will not operate over 700 psi (4.9 MPa, 49 bar)
for either A or B.
6.
To exit jog mode, press
shows dashes or current pressure.
Jog Mode
to start motor.
to change jog speed
until display
309551C