First Activation Of A Configuration Pin Code; Changing An Existing Pin Code - Argus green stream 707 Service Manual

2.4. First activation of a configuration PIN Code

The activation of a PIN code allows you to protect the configuration from unauthorized
persons.
To activate the PIN code, enter the configuration mode as described in the previous
chapter. For this use the default PIN code "0":
1. To enter into the configuration mode, switch the pump on
while keeping the keys "MODE" and START/STOP" pressed.
5. Enter the default PIN Code "0". To do
this press the key "10" while keeping the
key "1" pressed. Press "START" key to
acknowledge the entered PIN code.
7. Enter now the new PIN Code (max. 4 digit number).
Please remember this code, it will never be visible
again!
After you switch the pump OFF and ON again you can enter the configuration mode only,
if you enter the correct PIN code in display of chapter 2.3.2.
Please note: The interrogation mode can always be accessed without the PIN.

2.5. Changing an existing pin code

Enter the configuration mode (see chapter 2.3), select address 0 and enter the new pin
code.
14.164.A_A707en.SM.V1.01.doc
707 prog
. . . 0
0
ARGUS Medical AG 10.02.04 AS
PUMP CONFIGURATIONS
2. Press key "START".
3. Press key "MODE".
4. Press key "START" again. The
3.
display will show "Cod ----".
Pre
6. Press the "MODE" key.
The flashing decimal
points will change to the
right hand display
8. Press key "START" to
acknowledge to new
PIN.
7 / 38