Table of Contents
Advertisement
3.2.2. Capturing text from the pump transmitted
If you intent to print out the configuration
or the history events transmitted from the
pump, you should capture the text transmit-
ted by the pump into a text file. To do this
please select "Capture Text" in the hyper
terminal's menu.
A "File box" will open; type a descriptive
name for the file, and then click "Start".
The terminal program starts to capture each
text received over the serial interface.
Stop the capturing after you did the re-
quired pump settings.
To do this select "Stop" in the menu "Cap-
ture Text" of the terminal program. You
will then have a text file including the data
transmitted by the pump.
3.3. Configuration printout
Connect the ARGUS 707 to your PC (see chap. 3.1) and setup the terminal program (see
chap. 3.2). Start to capture text on the PC side before you switch the pump on.
2. Select address 399 in the
left hand display.
By saving the transmitted configuration text, you may print it using any text program.
See the following example of a configuration printout:
14.164.A_A707en.SM.V1.01.doc
CONFIGURATION AND HISTORY PRINTOUT
1. Enter into the configuration mode
(see chapter 2.3).
.3.9.9. 3456
3. Enter value 3456 in the
right hand display.
ARGUS Medical AG 10.02.04 AS
4. Press the "START/STOP" key. The pump
will now transfer the actual pump
configuration as text.
12 / 38
Advertisement
Table of Contents
