Power Cable Connections; Start And Configure The Router - Cisco CISCO7206 Quick Start Manual

5

Start and Configure the Router

Power Cable Connections

Warning This unit might have more than one power cord. To reduce the risk of electric shock, disconnect the two power
supply cords before servicing the unit.
Warning The AC power supply has double pole/neutral fusing.
Connecting AC-Input Power
1
2
3
PWR OK LED
1
Power switch
2
AC power cable
3
1. At the rear of the router, check that the power switch (2) is in the off (O) position.
2. Slide the cable-retention clip (4) up, away from the AC port, and plug in the power cable (3).
3. Secure the cable in the power supply AC port by sliding the cable-retention clip down until it fits around the connector. The
cable-retention clip provides strain relief for the AC power cable.
4. For AC power cable strain relief, secure the cable to the power supply handle by inserting a nylon cable tie through the hole
(5) in the handle and around the cable.
5. Plug the AC power supply cable into the AC power source. Repeat Step 1. through Step 5. for the second power supply (if
present).
Connecting DC-Input Power
The color coding of the DC-input power supply leads depends on the color coding of the DC power source at your site.
Note
Typically, green or green/yellow is used for ground. Make certain the lead color coding you choose for the DC-input
power supply matches lead color coding used at the DC power source.
Warning When you install the unit, the ground connection must always be made first and disconnected last.
14
5
4
Cable-retention clip
4
Hole for nylon cable
5