Table of Contents
Advertisement
Cisco 7200
Series
3
2
1
Cable-management bracket
2
Rack-mount bracket
Brackets Front-Mounted—Chassis Recessed in Rack
Locate the rack-mount and cable-management brackets and screws (1, 2, 3 in the illustration above) and a Number 2 Phillips
screwdriver.
1. Align the cable-management bracket (1) to the side of the router. Align the rack-mount bracket over it—as shown
above—and insert and tighten the screws (3).
Go to the "Two-Post or Four-Post Rack Installation" section on page 10.
2. If you are not using the cable-management brackets, align the rack-mount brackets (2)—as shown above—to the router and
insert and tighten the screws.
Go to the "Two-Post or Four-Post Rack Installation" section on page 10.
8
1
3
ETHERNET-10BFL
FAST ETHERNET INPUT/OUTPUT CONTROLLER
M4 x 8-mm Phillips flathead screws
Advertisement
Table of Contents
