Over Clock Running - JETWAY 695AS User Manual

This motherboard Provides a ZIF Socket 370. The CPU that comes with the motherboard
should have a cooling FAN attached to prevent overheating. If this is not the case, then
purchase a correct cooling FAN before you turn on your system.
WARNING! Be sure that there is sufficient air circulation across the processor's
heatsink and CPU cooling FAN is working correctly, otherwise it may
cause the processor and motherboard overheat and damage, you may install
an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF socket and
open it by first pulling the level sideways away from the socket then upward to a 90-degree
angle. Insert the CPU with the correct orientation as shown below. The notched corner
should point toward the end of the level. Because the CPU has a corner pin for two of the
four corners, the CPU will only fit in the orientation as shown.
When you put the CPU into the ZIF socket. No force require to insert of the CPU, then press
the level to Locate position sightly without any extra force.

2-3-3 Over clock Running

WARNING! This section is for experienced motherboard installer only. Over clocking
can result in system unstability or even shortening life of the processor.
After setting the Jumper JCK1, JCK2 you can choose overclock running by BIOS CMOS
SETUP UTILITY. When you entered CMOS SETUP UTILITY, choose "Miscellaneous
Control" you will see the screen as below then.
CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
Miscellaneous Control
11