JETWAY 695AS User Manual page 12

Table for the Pentium III and Celeron Socket 370 CPU
Celeron
Speed Bus
300/66 66MHz
333/66 66MHz
366/66 66MHz
400/66 66MHz
466/66 66MHz
500/66 66MHz
533/66 66MHz
533A/66 66MHz
566/66 66MHz
600/66 66MHz
633/66 66MHz
667/66 66MHz
700/66 66MHz
733/66 66MHz 11.0x
766/66 66MHz 11.5x
800/100 100MHz
850/100 100MHz
900/100 100MHz
3. CMOS RAM Clear: JBAT
WARNING: Make sure your computer is POWER OFF when you CLEAR CMOS.
Connect a jumper cap over pin 2 & 3 of this jumper for a few seconds, will clears
information stored in the CMOS RAM Chip that input by user, such as hard disk
information and passwords. After CLEAR CMOS, you must put jumper cap back to
pin 1 & 2 location and enter the BIOS setup (by holding down <DEL> during power-
up) to re-enter BIOS information (see BIOS SETUP).
Selections
Normal
Clear CMOS
Pentium III
Ratio Speed
4.5x 500E/100
5.0x 533EB/133
5.5x 550E/100
6.0x 600E/100
7.0x 600EB/133
7.5x 650E/100
8.0x 667/133
8.0x
8.5x

Because the Ratio are fixed by CPU Manufacture, users
9.0x
don't need to setting ratio any more, this table just for
9.5x
reference use.
10.0x
10.5x
8.0x
8.5x
9.0x
JBAT
1-2 (Default)
2-3 (momentarily)
Bus Ratio
100MHz 5.0x 700E/100
133MHz 4.0x 733/133
100MHz 5.5x 750E/100
100MHz 6.0x 800E/100
133MHz 4.5x 866/133
100MHz 6.5x 933/133
133MHz 5.0x 1.0B GHz/133
9
Pentium III
Speed Bus
100MHz
133MHz
100MHz
100MHz
133MHz
133MHz
133MHz
Ratio
7.0x
5.5x
7.5x
8.0x
6.5x
7.0x
7.5x