Setting Cpu Bus Clock & Memory Clock Jumper; Over Clock Running - JETWAY 626EMP Series User Manual

2-3-1 Setting CPU Bus Clock & Memory Clock Jumper
Setting the front side bus frequency and SDRAM frequency
The motherboard uses jumper less function for the front side bus frequency and SDRAM
frequency users don't need setting any jumper when plug the CPU in motherboard
For experience user looking for over clocking possibility, please refer to sec 2-3-2.

2-3-2 Over clock Running

This section is for experienced motherboard installer only. Over clocking
WARNING!
can result in system instability or even shortening life of the processor.
Users can choose over clock running by BIOS CMOS SETUP UTILITY. When you entered
CMOS SETUP UTILITY, choose "Miscellaneous Control" you will see the screen as below
then.
VIA C3 Clock Ratio
Auto Detect PCI/DIMM Clock
Spread Spectrum
** Current Host/PCI Clock is
Host/PCI Clock at Next Boot is
** Current DRAM Clock is 133MHz **
DRAM Clock at Next Boot is
+2.5V Select
↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
WARNING! The Design of this motherboard follows chipset and CPU vender's design
guideline. Any attempts to push beyond product specification are not
recommended and you are taking your own risk to damage your system or
important data.
components are able to tolerate such abnormal setting, especially CPU,
memory, hard disks, and VGA cards.
Phoenix – AwardBIOS CMOS Setup Utility
Miscellaneous Control
Default
Enabled
Disabled
100
133MHz
2.65V
F6:Optimized Defaults F7:Standard Defaults
Before over clocking, you must make sure your
8
Item Help
Menu Level >
F1:General Help