JETWAY 695AS User Manual page 22

(3) Turbo LED switch: TURBO LED
Since the motherboard's turbo function is always on. The turbo LED will remain
constantly on while the system power is on. You may wish to connect the Power LED
from the system case to this lead. See the figure below.
(4) Reset switch lead: RESET
This 2-pin connector connects to the case-mounted reset switch for rebooting your
computer without having to turn off your power switch. This is a preferred method of
rebooting in order to prolong the lift of the system's power supply. See the figure
below.
(5) Speaker connector: SPKR
This 4-pin connector connects to the case-mounted speaker. See the figure below.
(6) Power LED: POWER LED
The Power LED is light on while the system power is on. Connect the Power LED
from the system case to this pin.
(7) Power switch: PWR BTN
This 2-pin connector connects to the case-mounted power switch to power ON/OFF the
system.
(8) Wake On-LAN/Wake On-Modem Headers (3-pin) : WOL/WOM
This connector connects to a LAN/Modem card with a WAKE ON-LAN/Wake On-
Modem output. This connector power up the system when a wake up signal is received
through the LAN/Modem card.
NOTE: This feature requires that Wake On LAN or Ring In Wake up is enabled.
19