Required Tools And Equipment - Cisco uBR10012 Universal Broadband Router UBR10-FAN-ASSY= Installation Manual

Figure 5
1

Required Tools and Equipment

•
•
Steps
To install a fan assembly module into the Cisco uBR10012 router:
Remove the front cover by pulling the cover towards you.
Step 1
If you are installing the fan module (UBR10012-FAN-PLUS=), ensure that the Cisco IOS Release
Step 2
running on the Cisco uBR10012 router supports the PRODUCT ID LED/switch feature.
Using both hands, align the fan assembly module in the chassis, and push it back firmly. Make sure that
Step 3
the connectors on the fan assembly securely connect to the backplane.
Tighten the captive screws on each side of the fan assembly module.
Step 4
To tighten the captive screws on the fan assembly modules, the installation torque used should be
Note
8 in-lbs.
Check if the fans start working and ensure that air is blowing from the fans.
Step 5
Verify that the FAN OK LED is illuminated (green). If the FAN OK LED is not illuminated or if the fan
Step 6
failure (SINGLE FAN FAIL or MULTI FAN FAIL) LEDs are illuminated (yellow), try reseating the fan
assembly module, see
OL-5093-02
EMI Gasket Location on the Cisco uBR10012 Router
EMI gaskets on either side on the fan
assembly on the Cisco uBR10012 router
chassis.
Flat-head screw driver
Fan assembly module (UBR10-FAN-ASSY= or UBR10012-FAN-PLUS=)
"Troubleshooting the Fan Assembly" section on page
Installing the Fan Assembly Modules in the Chassis
1
—
Cisco uBR10012 Universal Broadband Router Fan Assembly Module
1
23.
15