Table of Contents
Advertisement
On startup, it may take up to 30 seconds for the fans to stabilize at the appropriate speed.
Note
Three LEDs indicate the status of the fan assembly.
assembly module. In addition, there is a PRODUCT ID LED/switch on the front panel of the fan
assembly module (see
Figure 3
Table 2
Table 2
Ordered Equipment
Fan module (spare)
Fan module and Cisco uBR10012 chassis running unsupported Cisco IOS Release Not activated
Fan module and Cisco uBR10012 chassis running supported Cisco IOS Release
1. For information on Cisco IOS Releases that support the PRODUCT ID LED/switch feature, see the
Release Notes for Cisco IOS Release
If the PRODUCT ID LED/switch is illuminated (green), the Cisco IOS software identifies the fan
assembly module as UBR10012-FAN-PLUS only if you are running a supported Cisco IOS release on
the chassis. Otherwise, the software reports the default UBR10-FAN-ASSY product part number and a
FAN-MISSING alarm may be randomly raised. To clear the alarm, see
Assembly" section on page
Tip
Use a small object, such as a paper clip, to press the PRODUCT ID LED/switch inside the cavity on the
front panel of the fan assembly module.
OL-5093-02
Figure
3).
Front Panel of the Fan Assembly Module (UBR10012-FAN-PLUS)
UBR10012- FAN-PLUS
lists the default activation status of the PRODUCT ID LED/switch when it is shipped.
PRODUCT ID LED/Switch Default Activation Status
12.2(33)SCE.
23.
Table 1
lists the LEDs on the front panel of the fan
Cisco uBR10012 Universal Broadband Router Fan Assembly Module
Overview
PRODUCT ID
LED/Switch Status
Activated
1
Activated
Cisco uBR10012 Router
"Troubleshooting the Fan
5
Advertisement
Table of Contents
