Cisco uBR10012 Universal Broadband Router UBR10-FAN-ASSY= Installation Manual page 20

Removing and Replacing the Fan Assembly Module
Figure 8
Prerequisites
No prerequisites exist for this task.
Required Tools and Equipment
Wire cutters to cut the cable tie wraps.
Steps
To remove the fan assembly cable:
Remove the front cover by lifting it up slightly, and then pulling it towards you.
Step 1
Remove the fan assembly
Step 2
Reach into the chassis and cut the tie-wrap to free the cable.
Step 3
Note
Disconnect the cable from the rear bracket (see
Step 4
Cisco uBR10012 Universal Broadband Router Fan Assembly Module
20
Fan Cable
Male connector
(see"Removing the Fan Assembly Module" section on page
Ensure that you make notes of the securing points of the tie wrap before you remove them. The
tie wrap securing points are required while replacing the fan cable.
Female connector
Figure 9).
17).
OL-5093-02