Cisco uBR10012 Universal Broadband Router UBR10-FAN-ASSY= Installation Manual page 19

Figure 7
Pull the fan module out of the router chassis.
Step 4
Caution The fan assembly module weighs approximately 30 pounds. Use one hand to pull the fan assembly
module using its handle and position the other hand underneath the module to support it, so that it does
not suddenly swing down when it clears the chassis.
What to do next
After performing this task, install the fan assembly module, see
section on page
Fan Assembly Cable" section on page
Removing the Fan Assembly Cable
This procedure is applicable to both the fan modules (UBR10-FAN-ASSY= and
UBR10012-FAN-PLUS=).
The fan assembly cable connects the fan assembly to the backplane. The cable is located inside the
chassis, underneath the fan assembly. Normally, the cable is not removed when a fan assembly module
is removed from the chassis (see
Note The cable has different connectors on each end.
OL-5093-02
Locations of Screws
CIS CO
100 00
CIS CO
14. If you are also removing and replacing fan assembly cable, see the
19, and
Figure 8).
Cisco uBR10012 Universal Broadband Router Fan Assembly Module
Removing and Replacing the Fan Assembly Module
"Install the Fan Assembly Module"
"Replacing the Fan Assembly Cable" section on page
"Removing the
22.
19