Removing The Rear Mounting Front Perc Module - Dell EMC XC Core XC7525 Installation And Service Manual

Figure 53. Installing the front mounting front PERC module
Next steps
1. Reconnect all the required cables.
2. If removed, Install the air
3. Install the drive backplane
4. Follow the procedure listed in

Removing the rear mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the drive backplane
4. If installed, Remove the air
5. Remove the drive backplane.
6. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
NOTE: The mounting bracket for the 24 x 2.5-inch backplane is on the right of the backplane. The removal of the PERC
module is on the right side of the backplane.
2. Slide the front PERC module to disengage from the connector on the drive backplane.
shroud.
cover.
After working inside your
Safety instructions.
Before working inside your
cover.
shroud.
system.
system.
Installing and removing system components 61