Table of Contents
Advertisement
NOTE:
You can enter the Service Tag only when the Service Tag field is empty. Ensure that you enter the correct
Service Tag. After the Service Tag is entered, it cannot be updated or changed.
5. Click OK.
LOM card and rear I/O board
Removing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the system
board.
Steps
1. Using a Phillips # 2 screwdriver, remove the screws that secure the LAN on Motherboard (LOM) card and rear I/O board to
the system board.
2. Holding the edges, pull the LOM card or rear I/O board to disconnect from the connector on the system board.
Figure 121. Removing the LOM card and rear I/O board
Next steps
1.
Install the LOM card and rear I/O
Installing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the system
board.
120
Installing and removing system components
Safety
instructions.
Before working inside your
board.
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
