Specifications; Troubleshooting Guide - Heath Zenith Secure Home DualBrite 4541 Manual

SPECIFICATIONS

Range . . . . . . . . . . . Up to 30 ft. (9.1 m)
Sensing Angle . . . . . Up to 180°
Electrical Load. . . . . 14 Watt LED
Power Requirements 120 VAC, 60 Hz
Operating Modes . . . TEST, AUTO, and
Time Delay . . . . . . . 1, 5, 10 minutes
D B Timer . . . Off, 3, 6 hours, dusk-to
®
ual rite
HeathCo LLC reserves the right to discontinue
products and to change specifications at
any time without incurring any obligation
to incorporate new features in products
previously sold.
SYMPTOM POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on.
2. Fuse is blown or circuit breaker
3. Daylight turn-off is in effect
4. Incorrect circuit wiring, if this
Light comes on
1. Light control may be installed
in daylight.
2. Light control is in Test. (Set
Light comes on
1. Light control may be sensing
for no apparent
reason.
2. Sensitivity is set too high.
200257-02
[varieswithsurrounding
temperature]
MANUAL MODE
dawn

TROUBLESHOOTING GUIDE

is turned off.
(recheck after dark).
is a new installation.
in a relatively dark location.
control switch to an ON-TIME
position.)
small animals or automobile
traffic (Reduce sensitivity).
(Reduce sensitivity.)
SYMPTOM POSSIBLE CAUSE
Light stays on
1. Light control is detecting a heat
continuously.
2. Light control is in Manual Mode.
3. Light control is in D
4. Sensitivity is set too high. (Re-
Light flashes
1. Sensor is in the Test mode.
on and off.
2. Heat being reflected from other
Light does not
1. Nearby large, light-colored
stay on in Man-
ual mode.
5
source like an air vent, dryer
vent, or brightly-painted heat-
reflective surface. (Reduce
sensitivity.)
(Switch to Auto.)
ual
mode.
duce sensitivity.)
(While in TEST mode, light only
stays on for 5 seconds.)
objects may be affecting the
sensor. (Reduce sensitivity.)
objects reflecting light may
trigger the shut-off feature. Do
not point other lights at the
sensor.
B
®
rite