Specifications; Troubleshooting Guide - Heath Zenith Secure Home DUALBRITE SH-4300-BK4-B Manual

SPECIFICATIONS

Range ........................... Up to 30 ft. (9.1 m) [varies
Sensing Angle .............. 360°
Electrical Load .............. Up to 100 Watt Maximum
Bulb Type ...................... Candelabra Base, Type
SYMPTOM
POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on.
2. Bulbs are loose or burned out.
3. Fuse is blown or circuit breaker
4. Daylight turn-off is in effect (re-
5. Incorrect circuit wiring, if this is
Light comes on
1. Sensor may be installed in a
in daylight.
2. Sensor is in Test. (Set control
Light comes on
1. Sensor may be sensing small
for no apparent
reason.
200478-02
with surrounding tem-
perature].
Tungsten Incandescent
(Up to 25 Watt Maximum
each lamp holder).
"B", 25 Watt Maximum

TROUBLESHOOTING GUIDE

is turned off.
check after dark).
a new installation.
relatively dark location.
switch to an ON-TIME position.)
animals or automobile traffic.
(Reduce sensitivity.)
Sensor Capacity ........... Up to 200 Watt (1.7 A.)
Power Requirements .... 120 VAC, 60 Hz
Operating Modes .......... TEST, AUTO/ACCENT,
ON-Timer ...................... 1, 5, 10 minutes
D B Timer .......... Off, 3, 6 Hrs, Dusk-to-
®
ual rite
SYMPTOM
POSSIBLE CAUSE
Light stays on
1. There is a heat source like an
continuously.
2. Light control is in Manual Mode.
3. Light control is in D
4. Sensitivity is set too high.(Reduce
Light flashes on
1. Sensor is in the Test mode. (While
and off.
Light does not
1. Nearby large, light-colored objects
stay on in Man-
ual mode.
7
Maximum Tungsten In-
candescent
and MANUAL MODE
Dawn
air vent, dryer vent, or brightly-
painted, heat-reflective surface in
the coverage area. (Install shield
on sensor in the direction of heat
source.)
(Switch to Auto.)
ual
mode.
sensitivity.)
in TEST mode, light only stays on
for 5 seconds.)
reflecting light may trigger the
shut-off feature. Do not point other
lights at the sensor.
B
®
rite