Bosch WFVC VISION 16 Repair Instructions page 32

5.1.20 Installing door seals (boots / gaskets)
Door seals are held to the front shield and tub by spring clamps.
Installing them can be tricky unless the following procedure is used.
1) Align door seal so notch (for spring) at front is centered under
bottom of door.
2) Carefully push rear of seal over front of tub so seal properly
seats onto tub.
3) Stretch rear spring clamp over seal and insert into notch at rear
of seal.
4) Using small hose clamp, attach dispenser hose to seal.
5) Work front seal lip over front shield flange (so lip "snaps" in). Tug
around entire seal to check if seated.
6) Align clamp spring at door bottom, then insert front spring clamp
into notch of entire left half of door seal (180º from top to bottom).
7) While pulling right side of spring using needle-nosed pliers, pull
clamp into right side seal notch, then carefully release spring.
Hold clamp next to front shield so clamp won't pull seal off.
702_58300000143607_ara_en_a
5.1.21 Serial # (E-Nr) label
The serial # label, located on the front panel under the door, shows
the model (E-Nr) and serial # of the washer.
Page 32 of 42