Bosch WFVC VISION 16 Repair Instructions page 24

Don't force controls out from fascia panels to avoid breaking plastic
parts. If modules don't come out easily, the procedure hasn't been
followed and plastic parts will break.
Don't cut cable mounts – cut cable ties holding cables to mounts.
When reassembling, use new cable ties.
Some controls have been wrongly replaced since fault codes stored in
washer or motor controls can't be cleared. Controls are operating
properly and shouldn't be replaced to clear fault codes.
m CAUTION – 75% of all controls returned
for analysis check out OK.
issues are due to loose connections.
5.1.4 Button caps (round / rectangular)
All button caps don't snap onto buttons, but fit loosely onto buttons –
held in place by the control after reassembly. When reassembling
fascia (control) panels, set panels face down so button caps don't fall
out.
702_58300000143607_ara_en_a
Most control
5.1.5 Round button assembly
The (clear) round button assembly is connected by delicate plastic
rods. When removing buttons, gently pry out and remove them as a
group, not individually.
5.1.6 Rear panel
Remove top panel (5.1.1) for better access to parts. Remove (18)
M4x11 T-20 Torx screws, then pull out panel until top tabs clear.
Don't remove the top rear panel (with "H" & "C" stampings).
Rear panel access is best for most repairs.
Page 24 of 42