Bosch WFVC VISION 16 Repair Instructions page 26

Once the door hook screw has been removed, remove the remaining
five (5) T-20 Torx screws from the inner door frame. Lift the inner
frame from the door and lift the door glass bowl from the door. The
door glass bowl is keyed where it will fit into the door only one way.
The hinge must be removed before the outer door glass cover can be
removed. Simply lift the hinge from the inner ring, taking care not to
lose the four (4) white hinge bushings.
Lift up the inner ring and the outer door glass cover from the outer
door frame. Note their positions as parts are keyed and fit one way.
702_58300000143607_ara_en_a
5.1.10 Front panel
Remove top panel (5.1.1), fascia (control) panel (5.1.2), bottom front
panel (5.1.7) and door (5.1.8).
Disconnect door seal (boot / gasket) from front panel by removing
spring clamp and carefully separating seal lip from panel.
Remove two screws holding top and two screws holding bottom of
front panel to washer frame, then lift front panel up until it clears four
(4) plastic mounting tabs.
Unlatch drain pump "funnel" from front panel.
Page 26 of 42