Omron CK3E Series Hardware User Manual page 68

4 Mounting and Wiring
Manufacturer
Cisco Systems,
Inc.
Contec USA,
Inc.
Phoenix Contact
USA
Twisted-pair Cables and Connectors
Applicable EtherNet/IP communications cables and connectors vary depending on the used baud rate.
For 100Base-TX and 10Base-T, use an STP (shielded twisted-pair) cable of category 5 or higher. You
can use either straight or cross cable.
For 1000Base-T, use an STP (shielded twisted-pair) cable (double shielding with aluminum tape and
braiding) of category 5e or higher. You can use either straight or cross cable.
Cabling materials used for EtherNet/IP communication cables are shown in the table below.
"100Base-TX" in the "Product" column of the table below indicates that either 100Base-TX or 10Base-
T can be used.
For 1000Base-T
and 100Base-TX
For 100Base-TX
*1. We recommend that you use cables and connectors in above combinations.
Attaching the Connectors to the Cable and Pin Assignments
Use straight wiring to attach the connectors to the communications cable, as shown below.
4-18
Model
Consult the manufacturer.
http://www.cisco.com/
Consult the manufacturer.
http://www.contec.com/
Consult the manufacturer.
https://www.phoenixcontact.com
Product
Size and con- Cable
ductor pairs:
AWG 24 × 4
pairs
*1
RJ45 Connec-
tors
Size and con- Cable
ductor pairs:
*1
AWG22 × 2P
RJ45 Assembly
Connectors
CK3E-series Programmable Multi-Axis Controller User's Manual Hardware (I610)
Description
Manufacturer
Hitachi Metals, Ltd.
Kuramo Electric Co.
JMACS Japan Co., Ltd.
Panduit Corporation
Kuramo Electric Co., Ltd.
JMACS Japan Co., Ltd.
OMRON
Model
NETSTAR-C5E
SAB 0.5 × 4P CP
KETH-SB
IETP-SB
MPS588
KETH-PSB-OMR
PNET/B
XS6G-T421-1