Omron CK3E Series Hardware User Manual page 34

1 Features and System Configuration
 Ethernet Network Configuration
The Ethernet communications port on the Programmable Multi-Axis Controller supports the Ether-
Net/IP protocol. It can be connected to devices such as a PLC or a programmable terminal that
supports the EtherNet/IP protocol.
The Ethernet communications port can also be used for Modbus-TCP communications.
EtherNet/IP communications support targets only, so originators are required for the communica-
tions. If the originator in use is an NJ/NX-series CPU Unit, refer to the NJ/NX-series CPU Unit Built-
in EtherNet/IP Port User's Manual (Cat. No. W506) for details.
CPU Unit connection settings are required for EtherNet/IP communications. Refer to the Power
PMAC IDE User Manual (Cat. No. O016) for details.
 Support Software
Connect a computer with the Support Software installed to the Motion Controller via the Ethernet
network.
Refer to 1-3 Support Software on page 1-5 for details of the Support Software.
1-4
CK3E-series Programmable Multi-Axis Controller User's Manual Hardware (I610)