ECS P6EXP-Me Manual page 29

Soft-Off by PWR-BTTN
Under ACPI (advanced configuration and power interface) the system can be turned off
mechanically (by the power button) or it can undergo a software power off. If the system
has been turned off by software, the system can be resumed by a LAN, MODEM or
ALARM wake up signal. This item allows you to define a software power off using the
power button. If the value is set to Instant-Off, the power button will automatically cause a
software power off. If the value is set to Delay 4 Sec. the power button must be held down
for a full four seconds to cause a software power off.
CPUFAN Off In Suspend
If this item is enabled, the processor cooling fan will turn off when the system is in suspend
mode.
PowerOn by Ring
If this item is enabled, it allows the system to resume from a software powerdown
whenever there is an incoming call to an installed fax/modem.
Resume by Alarm
If this item is enabled, it allows the system to resume from a software powerdown
whenever a pre-set wake up alarm time is reached. If you enable this item, two items
appear below which allow you to set the date and time of the wake up alarm.
Wake Up On LAN
If this item is enabled, it allows the system to resume from a software powerdown
whenever there is incoming traffic to an installed network adapter.
IRQ 8 Break Suspend
When this item is enabled, any activity through the system interrupt request line 8 can reset
power-saving mode timeouts to zero, or resume the system from a power saving mode.
IRQ 8 is normally used by the system realtime clock.
IRQ[3-7, 9-15],NMI
When this item is enabled, the system will restart the power-saving timeout counters when
any activity is detected on the system interrupts (IRQs) and the non-masked interrupt
(NMI).
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
Floppy Disk
When these items are enabled, the system will restart the power-saving timeout counters
when any activity is detected on any of the drives or devices on the primary or secondary
IDE channels, or any of the drives connected to the floppy disk drive controller
Serial Port
Parallel Port
When these items are enabled, the system will restart the power-saving timeout counters
when any activity is detected through the system's serial ports, or the parallel port.
26
Default: Instant-Off
Default: Enabled
Default: Enabled
Default: Disabled
Default: Enabled
Default: Disabled
Default: Enabled
Default: Disabled
Default: Disabled
Default: Disabled
Default: Disabled
Default: Disabled
Default: Enabled
Default: Disabled