Table of Contents
Advertisement
Install the Processor
This mainboard is installed with a PGA370 ZIF processor socket. This socket will
only support the PPGA Celeron processor. Do not try to insert a socket-7 processor
such as a Pentium or Pentium-compatible processor. The Celeron processors all run
over a 66 MHz system bus and have internal clock speeds ranging from 300 to 400
MHz. Configuration of the processor is made automatically using the mainboard BIOS
(see the Setup chapter).
Follow the steps below to install the Celeron processor in the PGA370 socket.
1. Locate the zero insertion force (ZIF) PGA370 socket for the processor.
2. On the socket and on the processor, identify the pin 1 corner. You can identify the
pin 1 corner by noting that in the rectangular matrix of holes on the socket, one
hole is absent on two corners. The front corner with the absent hole is the pin-1
corner. On the processor, the pin-1 corner is beveled. (see the illustration below).
3. Push the socket locking lever away from the socket to unhook it. Swing the lever
into the upright position.
4. Insert the processor into the socket taking care that you have matched the pin 1
corners. No force is required, and the processor should seat smoothly into the
socket.
Processor
Socket
PGA370
8
Typical Socket-PGA370
Pin-1 corner
Locking Lever
Locking lever
Pin-1 Corner
Pin-1 Corner
Advertisement
Table of Contents
