ECS P6EXP-Me Manual page 17

6. Locate the bank of switch and indicator connectors PANEL1. These connectors
provide control functions to your system case. Use the table below to make the
connections.
7. The mainboard has wake up connectors for an optional network adapter or an
optional internal fax.modem card. If you have installed a network adapter
expansion card, connect it to the wake on LAN connector WOL1. If you have
installed an internal fax/modem expansion card, connect it to the wake on modem
connector WOM1.
8. The mainboard has four audio connectors. CD-IN is a 4-pin audio connector
which can be used to input the audio from a CD-ROM or DVD drive. J2 is exactly
the same, except that it supports an alternative kind of connector. Use either CD-
IN or J2 to connect your CD/DVD drive audio output. If you have installed a
device which supports SPDIF digital audio, you can connect the device to the
SPDIF output connector SPDIF. If you disable the built-in audio and install a
Sound Blaster PCI sound card, you can connect it to the SB-Link connector SB
LINK1. SB-Link allows a PCI Sound Blaster card to function correctly while
playing DOS real-mode games.
14
22 21
Function
Power SW
Speaker
Suspend SW
Reset SW
Power Indicator
HDD LED
Keylock
Green LED
Green Indicator
Keylock
Hard Disk
Speaker
Indicator
Power LED
Reset Switch
2 1
Suspend Switch
PANEL1
Power Switch
Pins
1, 3, 5, +7
+2, +4, 6
+8, 10
+13, 14
+15, 16
17, 18
19, 20
21, 22
WOL1
WOM1