Empire Comfort Systems Boulevard MULTIFUNCTION REMOTE DVLL60BP90N-2 Installation Instructions Manual page 2

SAMPLE WARNINGS AND DEFINITIONS:
Indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTICE: Addresses practices not related to personal injury.
1. Read the safety information on pages 57 - 58.
2. If located in the Commonwealth of Massachusetts, please
note the special requirements on page 59.
3. Are you going to install a blower into the fireplace? See
pages 8 - 10.
4. Where are you going to install the fireplace? See page 13.
5. Frame the opening. See page 20.
6. Install the gas lines. See pages 16 - 17.
7. Install the wiring. See pages 18 - 19.
8. Install the venting. See pages 24 - 33.
9. Install the fireplace. See pages 20 - 23.
10. Install the remote system. See pages 38 - 45.
11. Liner requirements. See page 36.
12. Install the glass media. See page 37.
13. Light the fireplace and troubleshoot. See pages 46 - 48.
14. Show the homeowner how to operate the fireplace.
15. Show the homeowner how to do the basic maintenance.
UNPACkING THE FIREPLACE
1. Remove crate boards as needed using a screw gun to
remove wood screws.
2. Remove top hand-bent top brackets (2) securing the long 2 x
4 board. Remove the 2 x 4 board and corner posts.
3. Remove non-combustible boards and heatshield from pallet
and set aside.
4. Lift fireplace off of the pallet.
HOMEOWNER REFERENCE INFORMATION
Record the following information about your fireplace.
Model: ____________________________________
Serial Number: _____________________________
Dealership: ________________________________
Notes: ______________________________________________________________________________
____________________________________________________________________________________
Page 2
BEFORE YOU START
DANGER
WARNING
CAUTION
5. Verify that the fireplace and components have not been
damaged during shipping.
6. Set fireplace in a location near to its final installation location.
INSTALLATION CONSIDERATIONS - FIREPLACE
INSTALLATION GUIDELINES
When planning a fireplace installation, it's necessary to determine:
• Gas supply piping (right side entrance).
• Electrical supply requirements
(120V, 60Hz, 1 Amp) (right side entrance)
• DVLL60BP models include the factory installed Accent Light
assembly.
• Proper opening size of framing required for installation of
the fireplace. The framing of the fireplace will determine how
the fireplace finishing materials will be applied. Refer to the
installation information pages 20 to 23.
• The blower kit is easier to install at the time of fireplace
installations. See blower installation section on pages 8 to 10.
In planning the installation for the fireplace, determine where the
fireplace is to be installed and whether optional accessories are
desired. Gas supply piping should also be planned at this time.
The fireplace can be mounted on any of these surfaces:
1. A flat hard combustible or non-combustible surface.
2. A raised platform of combustible or non-combustible material.
If the fireplace is installed directly on carpeting, tile or other
combustible material other than wood flooring, it should be
installed on a metal or wood panel extending the full width and
depth of the fireplace.
The fireplace is designed to be installed in a zero-clearance
enclosure. This means that combustible materials must be
located at clearances specified or provided by standoffs or
spacers attached to the fireplace.
Combustible materials can come in contact with the nailing
flanges provided.
Date purchased/installed: _________________
Location on fireplace: ____________________
Dealer Phone: _________________________
41117-0-0819