Verifying Correct Operation - IBM SAN128B-7 Installation, Service And User Manual

Storage networking
Table of Contents

Advertisement

Domain: (1..239) [1] 3
e) Complete the remaining prompts or press Ctrl+D to accept the remaining settings without
completing all the prompts.
f) Re-enable the switch by entering the switchEnable command.

Verifying correct operation

Perform the following steps to verify correct operation of the device.
1. Check the LEDs to verify that all components are functional.
2. Verify the correct operation of the device by entering the following commands from the workstation.
Command
psShow
fanShow
switchShow
tempShow
historyShow
errDump
The switchShow command provides the following information about the device and ports status.
G730switch:FID128:admin> switchshow switchName:
switchType:
switchState:
switchId:
switchWwn:
switchBeacon:
FC Router:
Fabric Name:
Allow XISL Use: OFF
LS Attributes:
Mode 0]
Index Port Address
==================================================
0
0
1e0000
reserved
yet) (output truncated)
94
94
1e5e00
reserved
yet)
95
95
1e5f00
reserved
yet)
96
96
1e6000
97
97
1e6100
(Trunk
master)
98
98
1e6200
reserved
yet)
99
99
1e6300
reserved
yet)
(output truncated)
The tempshow command shows the current temperature of the EM sensors.
switch:admin> tempshow
Sensor ID|Sensor Index|State
1
|0
2
|1
3
|2
Description
Displays power supply status and information
Displays fans status and information
Displays switch status and information
Displays temperature status and information
Displays the device history
Displays any errors
189.3
Online switchMode:
fffc1e
10:00:c4:f5:7c:02:31:98 zoning:
OFF
OFF
Serviceability_Testbed HIF Mode:
[FID: 128, Base Switch: No, Default Switch: Yes, Ficon Switch: No, Address
Media Speed
State
--
N64
No_Module
--
N64
No_Module
--
N64
No_Module
id
N64
Online
id
N64
Online
--
N64
No_Module
--
N64
No_Module
|Centigrade |Fahrenheit |
|Ok
|30
|Ok
|34
|Ok
|29
ras030
Native switchRole:
ON (WB_RAS159_64G_LSAN)
OFF
Proto
FC
(Ports on Demand license not assigned or
FC
(Ports on Demand license not assigned or
FC
(Ports on Demand license not assigned or
FC
E-Port
(Trunk port, master is Port 97
FC
E-Port
10:00:d8:1f:cc:03:3e:a0 "ras232"
FC
(Ports on Demand license not assigned or
FC
(Ports on Demand license not assigned or
|86
|
|93
|
|84
|
Chapter 4. Initial Setup and Verification 39
Subordinate switchDomain:
30
)

Advertisement

Table of Contents
loading

Table of Contents