Table of Contents
Advertisement
Figure 13. Positioning the device in the rack
Screws, 10-32 x 5/8-in., panhead Phillips
Retainer nuts, 10-32
Attaching the rear brackets to the extensions at the front of the device
Complete the following steps to attach the rear brackets to the extensions. There are short and long front
brackets that you can use for this step.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket onto the right extension.
The short rear brackets are shown in Figure 14 on page 22. Use the first and third vertical pairs of
holes for the screws.
Refer to Figure 15 on page 23 for the positioning of the short or long brackets and screws.
3. Attach the brackets using four 6-32 x 1/4-in. panhead screws.
4. Repeat step 2 and step 3 to attach the left rear bracket to the left extension.
5. Adjust the brackets to the rack depth and tighten all the 6-32 x 1/4-in. screws to a torque of 9 in-lb (10
cm-kg).
Chapter 3. Mounting the switch 21
Advertisement
Table of Contents
