Table of Contents
Advertisement
Figure 21. Attaching the rear brackets to the device
1. Screws, 8-32 x 5/16-in., panhead Phillips
Mid-mounting
Observe the following notes when using this procedure:
• The device must be turned off and disconnected from the fabric during this procedure.
• The illustrations in this document show a 1U device, but the instructions are the same for a 2U device.
• The illustrations in the rack installation procedures are for reference only and may not show the actual
device.
Complete the following tasks to install the device in a rack:
1. "Attaching the front brackets to the device" on page 29
2. "Attaching the front brackets to the rack" on page 30
3. "Attaching the rear brackets to the rack" on page 31
4. "Attaching the rear brackets to the device" on page 32
Attaching the front brackets to the device
Complete the following steps to attach the front brackets to the device.
1. Position the right front bracket with the flat side against the right side of the device, as shown in Figure
22 on page 30.
Chapter 3. Mounting the switch 29
Advertisement
Table of Contents
