Making A Template - JUKI PS-800SB-2850 Instruction Manual

4-16. Making a template

(1) Machining a template
2850 type template of dimensions of the maximum sewing range
・ Material of template: PVC plate
・ The template is a PVC plate thickness of which is 2 mm or less.
・ The whole thickness of the template should be 5 mm or less including the thickness of the fabric to be set.
Be aware that the template may interfere with the intermediate presser and the disk presser if its whole
thickness exceeds the aforementioned value.
・ Adjust the template size according to the cloths and/or pattern to be sewn.
The size must not exceed the maximum dimensions of the relevant specifications.
・ Check complexity of the pattern to be sewn. Then, select the sewing slits from the range of 6 mm to 8 mm
according to the complexity of the pattern.
・ Locus of sewing slits on the template should be designed according to the pattern to be sewn or intended
machining.
・ Select the suitable pattern carving machine. The template must be machined by the qualified engineers
who have successfully finished the on-the-job training.
・ After the completion of machining upper and lower templates, deburr the templates and the top surface of
the template mounting plate.
Position to which an
electronic label is attached
Slit width 6
X-direction sewing range 280
Slit width 6
– 31 –
Technical requirements
1. There is neither burrs nor acute edges at rims of
the template.
2. Determine the slit width within the range of 6 to
10 mm according to the pattern template. It is
normally set to 8 mm.
3. This figure only applies to the sewing machine
that has a sewing range of 280 x 500 (mm).