Chapter 2. Installation
INSTALLING THE OCTAL BRI/U MODULE
2-2
Figure 2-1 represents the actions required to properly install the
Octal BRI/U Module, as described in the Step/Action table below.
Instructions for Installing the Octal BRI/U Module
Step
Remove the cover plate from the appropriate option slot in the
1
ATLAS rear panel.
Slide the Octal BRI/U Module into the option slot until the
2
module is firmly positioned against the front of the chassis.
3
Secure the thumbscrews at both edges of the module.
4
Connect the cables to the associated device(s).
Complete installation of remaining modules and Base Unit as
5
specified in the Installation chapter of the ATLAS User Manual .
To ensure that the thumbscrews are securely fastened, use a
screwdriver to tighten them.
Octal BRI/U Module User Manual
Figure 2-1. Installing the Octal BRI/U Module
Action
61200186L2-1