Installation; Unpack & Inspect; Installing The Option Module - ADTRAN 1200068L1 HS Series User Manual

2. INSTALLATION

2.1 UNPACK & INSPECT
ADTRAN S
HIPMENTS
I
NCLUDE
C P
USTOMER ROVIDES
2.2 INSTALLING THE
OPTION MODULE
P OM
LACEMENT OF THE
November 1996
Carefully inspect the OCU DP module for any
shipping damages. If damage is suspected, file a
claim immediately with the carrier and then contact
ADTRAN customer service. If possible, keep the
original shipping container for use in shipping the
OCU DP Module back for repair or for verification of
damage during shipment.
• The OCU DP Option Module
• The OCU DP Option Module User's Manual
(To be inserted into main TSU 100 User's Manual)
• Cable for connection to DSU/CSU
Power to the TSU 100 should be OFF when install-
ing the OCU DP Module, PN 1200.068L1.
The OCU DP Option Module PN1200.068L1#HS, is hot
replaceable and can be installed in the TSU 100 with the
power On.
Figure 2 is representative of the action required
for proper placement of the Option Module.
• Remove the cover plate from the TSU 100 rear
panel.
• Slide the option module into the rear panel until it
is positioned firmly against the front of the TSU 100.
• Fasten the thumb-screws at both edges of the option
module.
61200.068L1-1C
CAUTION
5