Appendix A Dial Plan Interface Configuration; Figure A-1. Dial Plan Menus - ADTRAN Octal BRI/U User Manual

Appendix A
OCTAL BRI/U MODULE INTERFACE CONFIGURATION
OCTAL BRI/U MODULE: NETWORK TERMINATION
61200186L2-1
Dial Plan Interface Configuration
The I option for the D
C
FCE ONFIG
uration parameters for the endpoint. These parameters vary by the type of
port selected. The following section describes the configuration options
available for the Octal BRI/U Module. The D
sible when using terminal mode. To access these options, select D
from the ATLAS menu.
This section describes the network and user termination configuration set-
tings for the Octal BRI/U Module when using the D
lowing configurations are provided here:
• Octal BRI/U Module: Network Termination on page A-1
• Octal BRI/U Module: User Termination on page A-3
The Octal BRI/U Module can interface directly with the network (PSTN).
When you are working in the network termination section of the D
menu, and S is defined as a U-BRI module, the following interface config-
LT
uration options are available:
Octal BRI/U User Manual
menu (see Figure A-1) sets config-
P
IAL LAN
P menus are only acces-
IAL LAN

Figure A-1. Dial Plan Menus

P
IAL LAN
P
IAL LAN
menus. The fol-
P
IAL LAN
A-1