General Information; Summary Of Uc800 Display Upgrade; Unit Model Number - Trane Symbio 800 Installation Instructions Manual

General Information

Summary of UC800 Display
Upgrade
This manual also provides instructions and describes the
procedures required to upgrade an UC800 retrofit panel
equipped CVRE, CDUA chiller or an UC800 production
panel equipped HDWA, CVHE, CVHF, CDHE, CDHF, CDHG,
CVGF, CVHM, CVHS, CVHL, CVHH or CDHH chiller to a
Symbio display system.
Notice that the installation instructions in this manual are
divided into the following general topic areas:
1. Check the configuration and set-points in the
AdaptiView display.
2. Save the AdaptiView display configuration and set-
points.
3. Shut down power.
4. Remove the UC800 controller and replace with Symbio
800 controller.
5. Remove the old display and replace with new TD12
display.
6. Wiring connections to the new TD12 display and the
Symbio 800 controller.
7. Before restoring system power.
8. Restoring system power.
9. Programming the Tracer Symbio display.
CDUB-SVN002B-EN

Unit Model Number

For service purposes, Trane Model CDUB Symbio 800
AdaptiView display upgrade packages are assigned a
multiple character alphanumeric model number that
precisely identifies each unit.
An explanation of the identification code that appears on
the unit nameplate is shown in
service model number will enable the owner/operator,
installing contractors, and service technicians to define the
operation, components and options for any specific unit.
Refer to the model number printed on the nameplate when
ordering replacement parts or requesting service.
Figure 1, p. 7. Use of the
5