Communication Device Mounting - Trane Symbio 800 Installation Instructions Manual

Figure 19. Air-Fi terminals
Air-Fi wiring, ref. 50712795, 50712799, 50712802,
50712805 or 50712806 depend on different unit. For
details, see Table 3, p. 27.
Figure 20. Air-Fi terminals wiring
RED
1X3-1
BLK
1X3-2
BLU
1X3-3
IMC
A G G
- + - + - + - + +24
P1 P2 P3
BACKNET MODBUS MACHINEBUS
1A22 SYMBIO 800 UNIT CONTROLLER
ETHERNET
USB
1
1 2 3 4
LTE Modem Installation
Modem part is MOD03184, MODULE; CELLULABLE USB
2.9 METER CABLE. Refer to provided literature for setup
and operation details.
1. Drill a 1.36-inch holes on the top of polycarbonate box,
securely fasten the LTE modem by gasket and nut
which provided by modem.
2. Connect LTE modem to Symbio 800 by USB cable
which provide by module, plug USB MICRO-B side to
bottom of LTE modem and USB-A side to any one of
the four USB ports under the Symbio 800 controller.
LTE Modem wiring, ref. 50712795, 50712799, 50712802,
50712805 or 50712806 depend on different unit. For
details, see Table 3, p. 27.
CDUB-SVN002B-EN
OPTIONAL
4K48
AIR-FI
INTERFACE
IMC
G B
- + +24
VDC VDC
IMC
SERVICE
TOOL
2
Figure 21. LTE modem wiring
1A22 SYMBIO 800 UNIT CONTROLLER
OPTIONAL
4Y2
LTE
MODEM
TRACER
COMMUNICATIONS
OPTIONAL

Communication Device Mounting

There devices are intended to be mounted on
polycarbonate boxes. There are two installation
approaches,
1. Each device is mounted independently on a small box
(0185-0426-0100).
2. Multiple devices are mounted on a large box
(0185-0427-0100).
All devices connect Symbio 800 by standard USB or
Modbus cable. For installation standard application need
to field drill a 1.09-inch hole on side of box for a snap
bushing. This bush can be replaced as field straight
connector and conduit (3/4-inch size) as NEMA 4
applications.
The boxes have magnets for flexible attachment to the
Symbio panel.
Figure 22. Communication device mounting
Installation
ETHERNET
USB
1 2
1 2 3 4
1K47
LON
INTERFACE
17