Operation And Cycle Information - Haier GE CDT800P2N3S1 Technical Service Manual

2020 stainless steel tub dishwasher

Hide thumbs

Table Of Contents

Table of Contents

https://appliancetechmanuals.com

This section of the guide provides details on segments of cycles, timing of cycles, temperature

expectations, and cycling of the heater during the dry portion of a cycle.

Auto Hot Start

At the beginning of the main wash, the dishwasher checks the temperature of the water, and if it is

below 90°F, then it will add up to 10 minutes of time to heat the water to 90°F by circulating the water

while the heater is on. Similarly, at the beginning of final rinse, the dishwasher will check the water

temperature, and if it is below 105°F, then it will add up to 15 minutes of time to heat the water to 105°F.

Once it reaches the target temperature, any remaining hot start time will be truncated and will continue

on with the cycle.

The cycle chart explains the segments of a cycle (cycles for all models included, not all models contain

the same cycles). It details fill and drain times which depend on either a full or partial drain. It provides

the circulation time in each segment but does not include turbidity or temperature adjustments or dry

cycles (see the Dry System section in this guide). Times will vary depending on turbidity response and

incoming water temperature.

Cycle Option Selected

No Options

Sani-Steam