Tub Gasket - Haier GE CDT800P2N3S1 Technical Service Manual

https://appliancetechmanuals.com

Tub Gasket

Tub Gasket
The tub gasket seals the top and sides of the tub
to the door. The retainer is part of the stainless-
steel tub. The seal pushes into the retainer area
of the tub, and no sealant or RTV is used to
install the tub gasket. When installing the tub
gasket, there will be a 2-inch extension at the
bottom of the tub on each side.
2" of tub gasket extends toward
center of tub
To Remove Tub Gasket: Pull the gasket from the
retainer area.
Tub Gasket Installation
1. The center of the gasket has a mark
which is placed pointing to the inside of
the dishwasher. This position will orient
the gasket wiper to face the inside of the
dishwasher and to the inner door.
(Top of Dishwasher)
Tub Gasket
Retainer Track
Center Position Mark
2. Start by placing the mark down and align with
the tub latch. Push the gasket into the track,
working outward to the top corners.
3. Push the gasket into the track through the
corners, making sure the wiper portion of
the gasket does not turn inward or outward
causing the gasket to not have an even plane
around the corners. Stretching the gasket
may cause the gasket to roll in or out, which
will cause the new gasket to leak. If the
gasket wiper rolls in or out, pull the gasket out
of the track and reinsert into place.
The wiper on the Gasket
must make a smooth turn
through the corner
– 22 –
(Front of
Dishwasher)
Wiper
Flange
(Continued next page)