Tub And Structure; Tub Trim (Some Models); Toe Kick; Junction Box And House Wiring Connection - Haier GE CDT800P2N3S1 Technical Service Manual

https://appliancetechmanuals.com
The Tub and Structure section of this guide will
cover the toe kick, junction box, racks, leveling,
door balance, gaskets, trim (some models), main
control board, door, door components, as well
as the removing and separation of the screwless
appearance door. It will also cover the sump
module and removal. Details of the sump
components will be covered in the Circulation
System or Drain System sections of this guide.

Tub Trim (Some Models)

Some models include tub trim, which clips to the
plastic tub to reduce sound levels and provides a
cleaner appearance to the installation.
Tub Trim
If the cutout prevents the dishwasher from being
fully installed, or if the trim rolls inward preventing
the door from closing, it may be trimmed to
fit properly. The wiper edge must contact the
cabinet to be an effective sound barrier.
WARNING: GEA Factory Service Technicians
are REQUIRED to follow Lockout / Tagout
(LOTO) 6 Step Process prior to beginning
repair.

Tub and Structure

Trim if needed
– 20 –

Toe Kick

The toe kick panel is a safety and decorative
panel covering the machine area of the
dishwasher. The panel provides a safety barrier,
closing the front of the dishwasher machine
compartment. To remove the panel, remove two
1/4-in. hex-head screws and pull the panel away
from the dishwasher.
Toe Kick
Insulation
Junction Box and House Wiring
Connection
The junction box is located behind the toe kick
on the right-hand side of the dishwasher. The
junction box is where the 120 VAC house voltage
connects to the dishwasher. The dishwasher
may be hardwired, or an optional cord may
be installed (available separately, Part #:
WX09X70910), which plugs into a wall outlet
and connects to the harness plug into the control
(see the Installation Guide provided with the
appliance). The cover is held in place with a 1/4-
in. hex-head screw on the left side, and tab on
the right side. To remove the cover, remove the
screw and pull out and to the left to release the
tab. It is helpful to squeeze the top and bottom of
the box when removing and installing.
Toe Kick
Insulation
Junction Box
Mounting Screw
Toe Kick Screws
Ground Screws
Junction Box