Sx-T100 Telephone Coupler - Sony SX-M700 Service Manual

Location and Function of Parts and Controls
When the MIC ON/OFF button of the
delegate's unit is pressed under the condition
where the PRIORITY button of the chairman's
unit is held down, the MIC ON/OFF button
indicator and microphone indicator blink for
about 3 seconds to tell the user that the
microphone cannot be enabled.
9 REC OUT (recording output) connector
(minijack)
Connect to the input connector of the tape recorder
to record the monitor sound.
Note
Use a connecting cable with a terminating resistor
(RK-G64 and so on) to connect the unit to the
microphone input connector of a tape recorder.
Use a connecting cable without a terminating
register (RK-G69 and so on) to connect the unit to
the line input connector of a tape recorder.
!º Earphone jacks (minijack)
Connect an earphone to monitor the signal from
the interpreter's unit or the original signal.
12
http://getMANUAL.com

SX-T100 Telephone Coupler

1 CONTROL UNIT connector (6-pin multi-
connector)
Connect to the TELEPHONE COUPLER
connector of the SX-M100 Control Unit, using the
connecting cord supplied with the SX-T100.
2 Power indicator
This indicator lights when the telephone coupler
power is turned on.
3 POWER ON/OFF switch
Turns the telephone coupler power on or off .
Note
When the POWER ON/OFF switch is set to ON,
howling or noise may arise because the
microphone and the speaker are enabled. When the
telephone coupler is not used, set the POWER ON/
OFF switch to OFF.
1
CONTROL UNIT connector
2
Power indicator
3
POWER ON/OFF switch
Movable part A
4
Handset-securing tape
SX-T100 Telephone Coupler
4 Handset-securing tape
After being connected to other party telephone,
place your handset on the telephone coupler and
secure it with the handset-securing tape. Adjust the
movable part A in the above illustration, to fit the
handset being used.
Note
If the handset is not secured firmly,
communication may not be satisfactory.
13