Sony SX-M700 Service Manual page 13

Setting Up the System
How to connect cables of SX-C700A/D700A
The figure below shows how to connect and disconnect the 20-pin multi-
connectors of the chairman's/delegate's unit, RK-1700/1705 and RK-1710/1713
connecting cables.
When connecting When disconnecting
White mark
Grasp the knurled part of the
connector and pull it towards you.
With the white mark on the 20-pin
multi-connector facing up, push the
connector home until it clicks.
Turning On the Power of the System
POWER
I
ON
PHONE
O OFF
2
Telephone coupler
1
Turn on the power of the units connected to the EXT IN-1/2 connectors of the
control unit.
2
Set the POWER switch of the control unit to ON.
3
When necessary, set the POWER switch of the telephone coupler to ON.
18
When connecting When disconnecting
White mark
Grasp the knurled part
Meet the white marks on
of the connector and
each connector and push
pull it towards you.
the connectors each other
until they click.
VU
ORIGINAL
MONITOR MONITOR MIC/LINE 1 MIC/LINE 2 D/C UNIT MIC D/C UNIT SP
INTRT[TRYRT
5 5 5 5 5 MIC/LIMIT DIRECT ACCESS SEAT ASIGN
4 6 3 CHANNEL 4 6 4 6 4 6 4 6
2 4 ON/OFF ON/OFF START/END
3 7 3 7 3 7 3 7 3 7
1 5
2 8 2 8 2 8 2 8 2 8
ORIGINAL 6
1 9 1 9 1 9 1 9 1 9
MIN MAX 0 10 0 10 0 10 0 10
Control unit
3
Assigning Interpreted Languages to Channels
Assign the interpreted languages to the channels (1 to 6) of the interpreter's units
by using the MICROPHONE CHANNEL buttons of the interpreter's unit before
the start of conference.
MICROPHONE CHANNEL buttons
MONITOR
3
4
2 5
1 6
RELAY ORIGINAL
VOLUME
5
4 6
COUGH CUT
3 7
2 8
1 9
MIN MAX
Press the MICROPHONE CHANNEL button corresponding to the channel
assigned to the target language of each interpreter.
INTERPRETER'S UNIT SX-P700
MONITOR
3 4
2 5
MICROPHONE CHANNEL MICROPHONE CHANNEL
1 6
ORIGINAL RELAY
SLOW
VOLUME
MICROPHONE
5
4 6
ON OFF ON COUGH CUT
3 7
2 8
1 9
MIN MAX
19