Cisco MeetingPlace Video Integration Administrator's Manual page 32

Before You Install
Parameter
Initial Layout
Max Layout
Use Processor
Format (in the Video Schemes Settings section) H.263
Other parameters
Click OK.
Step 3
Check the Display all conference views check box.
Step 4
Click Add View.
Step 5
Step 6 Set the following parameters for the second view:
Parameter
Initial Layout
Max Layout
Use Processor
Format (in the Video Schemes Settings section) H.263
Other parameters
Step 7 Click OK.
Setting Video Schemes Parameters
Select the "Video Settings Schemes" profile that you want to edit and click the Edit button.
Step 1
The Edit Video Scheme dialog box appears.
In the "Max bit rate" field, click the maximum video bandwidth that you want this service to support.
Step 2
This number must be less than or equal to the bandwidth settings in Cisco MeetingPlace (and in
Cisco CallManager, if your network uses Cisco CallManager.)
Note
Check Allow dynamic scheme to enable the Cisco IPVC MCU to switch the conference video
Step 3
bandwidth to a lower value when a less capable endpoint joins the conference.
•
To save these Video Scheme changes and to close this dialog box, click OK.
Step 4
Administrator's Guide for Cisco MeetingPlace Video Integration Release 5.3
3-10
Endpoints that are not capable of supporting this bandwidth receive only the conference audio
unless dynamic scheme is allowed.
In the "Min bit rate" field, click the lowest bandwidth that you want this parameter to support.
Chapter 3 Installing Cisco MeetingPlace Video Integration
Value
Desired multiple participant layout (for example,
4 participant)
Desired multiple participant layout (for example,
4 participant)
EMP
As desired
Value
1-participant layout
1-participant layout
MP
As desired
OL-6280-01