Cisco MeetingPlace Video Integration Administrator's Manual page 29

Chapter 3 Installing Cisco MeetingPlace Video Integration
Setting the Core Service Parameters
Click MCU on the sidebar and click the Services tab.
Step 1
Click the Add button.
Step 2
The Select Service dialog box appears.
To create a new service, click OK.
Step 3
The Add Service dialog box appears.
In the "Service prefix" field, enter the value that you want to use for the Cisco MeetingPlace service.
Step 4
Step 5 Uncheck the SCCP Service check box. Users of SCCP endpoints can still attend Cisco MeetingPlace
conferences.
In the "Service description," enter the description for this service that you want to appear on the Create
Step 6
Conference page.
In the "Media types" section, check Video.
Step 7
Note
Step 8 Specify the number of ports that you want the Cisco IPVC MCU to reserve for each conference as
follows:
a.
Tip
b.
Setting Audio Indications
We recommend that you enable all audio-indication parameters.
Click the Indications button.
Step 1
The Indications Settings dialog box appears.
Make sure that all parameters are checked.
Step 2
Click OK.
Step 3
OL-6280-01
Cisco MeetingPlace provides data collaboration in conferences. Disable data collaboration in
the Cisco IPVC MCU if it is currently enabled.
In the "Reserved number of parties" field, enter 2.
One of these ports is reserved for the Cisco MeetingPlace server.
Note
You can ascertain the maximum number of ports this service can support by entering 200 in the
"Maximum number of parties" field and choosing OK at the bottom of the page. The error
message that appears indicates the maximum number of ports the current configuration allows
based on the video bandwidth value specified in the Conference Views section.
In the "Maximum number of parties" field, enter the total number of Cisco IPVC MCU ports that
are available for conferences.
Administrator's Guide for Cisco MeetingPlace Video Integration Release 5.3
Before You Install
3-7