Checking The Hydraulic Lines; Cleaning; Removing Debris - Toro MB-1600 Operator's Manual

Replacing the Hydraulic Filter (continued)
3. Place a drain pan under the filter and replace it as shown:
4. Clean up any spilled fluid.
5. Start the engine and let it run for 2 minutes to purge air from the system.
6. Shut off the engine and check for leaks.
7. Check the fluid level in the hydraulic tank.
8. Install the cowl and secure the latches.

Checking the Hydraulic Lines

Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting supports,
wear, and deterioration. Make necessary repairs before operating.

Cleaning

Removing Debris

Operating the engine with blocked screens, dirty or plugged cooling fins, and/or
cooling shrouds removed, will result in engine damage from overheating.
1. Park the machine on a level surface and shut off the engine. Allow the engine to cool.
2. Unlatch and remove the cowl.
3. Clean any debris from under the hopper.
Maintenance: Hydraulic System Maintenance
g359049
IMPORTANT
Page 5–17 3451-702 A