JVC LT-32DP9BU Instructions Manual page 9

Install your TV
Power requirements

Connect the power cord only to a 220 - 240 V, 50 Hz AC outlet.

When attaching the TV to the wall, use the optional JVC wall mounting unit

Consult a qualified technician.

See the included manual on mounting procedures.

JVC assumes no responsibility for damage due to improper mounting.

Mounting holes for wall mounting unit:

M5 x 4, 200 mm x 200 mm
Depth of screw hole is 7 mm from the surface of the TV.
Installation requirements

Place the TV on the flat and stable location.

To avoid overheating, ensure the unit has ample room.

150 mm 50 mm
To prevent the TV from falling, thread the belt through the hole on the

back of the stand and secure it to the TV rack, etc.
Belt and screw (not provided)
200 mm
150 mm 50 mm
Hole
Watch pay-TV digital channels
Subscribe to a broadcasting company beforehand. A Smart Card (B) will
be sent by the broadcasting company after subscribing to it. It may be
necessary for you to purchase a Conditional Access Module (A) in addition
to the Smart Card.
Consult your broadcasting company or retailer.
1 Unplug the power cord
2 Insert "B" into "A".
3 Insert "A".
4 Plug the power cord, and turn the power on.
5 Perform necessary settings using "Common Interface". (P. 30)
Pay-TV analogue channels cannot be watched.

Insert the batteries
Use two "AAA/R03" dry cell batteries. Insert the batteries from the - end,
making sure the + and - polarities are correct.
Setting up your TV
A
B