JVC LT-32DP9BU Instructions Manual page 42

Supported music formats for Photo Viewer
Sample rate

32, 44.1, and 48 kHz (MPEG-1 Audio Layer-3)

16, 22.05, and 24 kHz (MPEG-2 Audio Layer-3)

8, 11.025, and 12 kHz (MPEG-2.5 Audio Layer-3)

Resolution

16 bit
Channels

monaural, stereo
Bit rate

32, 40, 48, 56, 64, 80, 96, 112, 128, 160, 192, 224, 256, and 320 kbps
Some files may not be able to playback depending on the combination

between the sample rate and the bit rate.
ENGLISH
Getting started
00Hz Clear Motion Drive II
Most conventional LCD panel uses 50 frames per second (50 Hz) to display
an image which needs long holding time (time it takes to display single
frame), causing blurring or ghost images when there is rapid or complex
movement across the screen - a phenomenon common to all LCD panels.
This TV is equipped with JVC's original "100Hz Clear Motion Drive II"
technology, which displays two frames (the original plus the new
interpolated frame) in the time a 50 Hz set displays a single frame.
Resulting to double the typical rate, 100 frames per second (100 Hz) and
halve the holding time without reducing brightness or contrast. By using this
technology you will be able to reduce blurring or ghost images when there is
rapid or complex movement across the screen.
By using "Auto Demonstration" (P. 34)", you can display the differences
between conventional LCD (50 Hz) and LCD panel equipped with "100Hz
Clear Motion Drive II".
Left side of the screen: Moving image of LCD panel equipped with "100Hz
Right side of the screen: Moving image of 50 Hz conventional LCD (50
*1 To simulate Moving image of conventional LCD, the TV will display two
same frames at a time.
When the images are 60 frames per second (60 Hz), it will be produced

as 120 frames per second (120 Hz)
Basics Advanced
Clear Motion Drive II" (100 frames per second)
frames per second)
*1
Etc.