Network Settings; 802.11B (Wireless Ethernet) - HP jetdirect 175x Administrator's Manual

Network Settings

The Network Settings pages allow you to set or change
configuration parameters for
IPX/SPX, AppleTalk, DLC/LLC, and
parameter setting, enter the desired value and click Apply.

802.11b (Wireless Ethernet)

The 802.11b pages allow you to create or change your wireless
network configuration parameters for your IEEE 802.11b wireless
ethernet connection. In addition, you may also configure basic
TCP/IP settings at the same time.
The configuration parameters are summarized in
more information on setting up your HP Jetdirect wireless print
server, see Appendix
The 802.11b tab displays a single, static page that contains all
wireless configuration parameters required to make a wireless
connection to your network. Click Apply to set or Cancel to ignore
your configuration entries. To reset to factory-default values, click
Reset to defaults.
Alternatively, you may choose to click the Use Wizard button at
the top of the 802.11b page to configure your wireless network
connection. This button will launch a configuration wizard that will
guide you through the required 802.11b wireless configuration
parameters and, depending on your choices, will bypass
unnecessary parameters.
Note
ENWW
802.11b (Wireless
B.
If you improperly exit the wizard (for example, by
failing to use the Cancel button), an Operation
Failed screen may appear. If so, wait approximately
two minutes before entering the wizard again.
Ethernet), TCP/IP,
SNMP protocols. To assign a
Using the Embedded Web Server 112
Table 4.3. For