Telnet Commands And Parameters - HP jetdirect 175x Administrator's Manual

Telnet Commands and Parameters.

available Telnet commands and parameters.
Note
Table 3.4 Telnet Commands and Parameters (1 of 18)
User Control Commands
Command
?
/
menu
advanced
general
save
exit
export
General Settings
Command
passwd
ENWW
If a parameter is supplied dynamically (for example,
from a BOOTP or DHCP server), its value cannot
be changed using Telnet without first setting
Manual configuration. To set Manual configuration,
see the ip-config command.
Whenever you are manually changing an IP
address, you should also reconfigure the subnet
mask and default gateway at the same time.
Description
Displays the Help and Telnet commands.
Displays current values.
Displays the
parameters.
Enables the Advanced commands. Help (?) will include the
Advanced commands in the list.
Disables the Advanced commands. Help (?) will not include
Advanced commands (default).
Save the configuration values and exit the session.
Exit the session.
Export the settings to a file for editing, and importing through
Telnet or TFTP (this command is only supported by systems,
such as UNIX, that support input/output redirection).
Description
Set the administrator password (shared with the embedded
Web server and HP Web Jetadmin). For example,
"passwd jd1234 jd1234" sets the password to jd1234.
Note that "jd1234" is entered twice for confirmation.
Up to 16 alphanumeric characters may be used. When
initiating the next Telnet session, you will be prompted for a
user name and this password.
To clear the password, enter the command without
password and confirmation entries.
Passwords may be cleared by a cold reset.
Table 3.4
Menu Interface for access to configuration
TCP/IP Configuration 81
lists the